SNES Style Multi-Out 3D Printed back panel, led, DC jack *A/V out* NES top load

SNES Style multiout port back panel with pallet NESRGB pallet switch mount. Connector board, 3D Printed back panel, DC Jack, and power LED ONLY ! ! NO SWITCH IS INCLUDED WITH THIS AS IT SHOULD COME WITH YOUR NESRGB KIT it is only on the picture for illustration purposes. ALSO NES NOT INCLUDED !

This 3D Printed back panel is printed using PLA filament and it is printed at normal speed to avoid any imperfections. I have other colors available, including RED, BLACK, SILVER and WHITE. This will avoid making holes on your console. If you are going to install NESRGB on your top loader this will allow you to use NES Scart cables, NES S-Video cables as well as SNES Composite cables. I designed this panel and have installed it on Top Loaders for customers that get the NESRGB board installed. Please note that the SNES Style edge connector board was designed by db-electronics and were purchased by me from Osh Park. Also note, that this does not come with NESRGB board, pallet switch or any video amp, however I do have composite video amps that will work with this if you are interested I offer that at an additional $10.


The NES 101 (NES2 or TOP LOADER) is the improved version of the Nintendo Entertainment System (NES). It's redesigned smaller has cartridge port on top. These units are more reliable since it does not have the NES10 lockout chip and tend not to damage the game cart since no need to insert it and push down weakening the pins on the console and cartridge. Unfortunately, these models did not have the composite video or audio out (AV RCA OUT). But with this add-on board, you can add SNES Style Multi-out video port. All you need to do is remove the RF adapter and power connector and solder the wires from your NESRGB board or composite video amp (also available from me). The edge connector has all pins marked so you can simply solder the corresponding wire that is needed.

If you do not feel comfortable installing this on your system, I also offer installation service that I add a video board and have audio out with a power led added to this as well. Please look at my other auctions if you are interested in that.

I include the following
1 Edge connector board with 3D Printed back panel ( See pictures )
1 Pre-wired RED led ready to solder in.
1 power DC Jack 2.1MMx5.5MM same as NES original (if you have aftermarket power adapter might not fit please check before purchasing)

Link to step by step instructions (emailed to you).

If you have any questions I am also available by email and if need be by phone to walk you through the process if the pictures and step by step guide is not enough.

You will need the following tools (NOT INCLUDED).
Security Bit 4.5 mm (Gamebit) can be found here on eBay for around $3
Small Phillips screwdriver
Small flat head screwdriver
Soldering Iron (preferably with a small tip)
Solder sucker / Solder wick
Tin Solder
Drill
an NES 101 (NES2)
and Possibly a small file.
***Please note that the Nintendo upgrade should only be attempted by a person with adequate soldering skills and equipment. No warranty is expressed or implied.